Stihl MH 710 - Attaching cables; Fastening the cables to the handlebar; Gearbox oil; Fuel and engine oil

ENFR
21
0478 404 8805 A - EN
● Position throttle cable (1) using cable
clip (2) so that the cable is tucked away
as neatly as possible and not touching
engine components.
7.9 Installing the carrying handle
● Unscrew bolts (1) together with
washers (2) and nuts (3).
● Discard bolts (1), washers (2) and
nuts (3).
● Install carrying handle (J) on the basic
unit using bolts (U3), washers (V5) and
nuts (W5).
Tightening torque: 35 - 40 Nm
7.10 Installing the guard plate holders
Installing the front right guard plate
holder
● Install front right guard plate holder (Q)
using bolts (U8) and washers (V4).
Installing the front left guard plate
holder
● Install front left guard plate holder (P)
using bolts (U8) and washers (V4).
Installing the rear guard plate holder
● Install rear guard plate holder (R) using
bolts (U10), washers (V3) and
nuts (W4).
Risk of injury!
Make sure that the tiller is stable.