Stihl RMI 422 PC-L - Page 30

0478-131-3050-A
28
English 10 Installing the Robotic Mower
NOTICE
Make sure that all contacts are clean and not corroded.
► Place the robotic mower (1) next to the docking station (2)
in the mowing area as illustrated.
► Press the OK button on the control panel.
► Disconnect the plug from the electrical outlet and press
the OK button.
► Remove the cover, @ 10.3.
► Press the OK button on the control panel.
To connect the perimeter wire to an internal docking station:
► Insert the perimeter wire (3) into the wire channels in the
base plate and guide it through the port (4) to the rear of
the docking station.
► Cut the ends of the perimeter wire (5 and 6) so that
approximately 15.7 in. (40 cm) is available for insertion
into the docking station. Additional length is not needed.
► Do not coil excess wire behind the docking station.
Excess wire can interfere with the operation of the robotic
mower.
To connect the perimeter wire to an external docking station:
► Guide the perimeter wire (3) though the wire channel in
the base plate (7). Thread the perimeter wire into the wire
channels. If necessary, loosen the wire stakes.
► Insert the perimeter wire (3) into the wire channels in the
base plate and guide it through the port (4) to the rear of
the docking station.
1
2
0000-GXX-3358-A2
0000-GXX-3359-A2
Unplug the
docking station
4
5
6
3
0000-GXX-5349-A0
7
7
3
4
0000-GXX-5350-A0