Using the truck with the "Tiller
always active — Creep Speed"
function (optional)
The "tiller always active" function can be ena-
bled when operating the truck in confined
spaces.
This function allows the truck to travel and
the forks to be lifted with the tiller in any posi-
tion. Unlike the standard version, by follow-
ing the instructions below, the truck functions
(travel and lifting/lowering of forks) are also
active with the tiller in the vertical position.
To enable truck lifting with the tiller in the verti-
cal position:
●
Press and hold the button (3)
●
Then press the fork lifting button
●
Release the button (3) to disable this func-
tion.
To enable travel with the tiller in the vertical
position:
●
Press and hold the button (3)
●
Then turn the throttle (4) in the desired di-
rection
●
The truck activates creep speed. During
travel at creep speed with the tiller in the
vertical position and the button (3) pressed,
if the operator tilts the tiller to the working
position (see
⇒
Chapter "Tiller positions",
Page 43 ), creep speed is disabled and the
speed of travel of the truck increases in line
with the angle of the throttle (4).
●
Release the button (3) to disable this func-
tion.
NOTE
If the activation sequence is accidentally re-
versed, i.e. with the tiller in the vertical posi-
tion, the throttle (4) is turned first and then the
button (3) is pressed:
●
The truck will move in creep speed as ex-
pected in the direction of the forks
●
Travel in the direction of the operator is not
enabled.
OM2283
3
4
4
Use
4
Using the truck
98 45758043484 EN - 11/2021 - 08
To Next Page
