Vibrations
Vibrations to which the hands and arms
are exposed
The following value is valid for all truck mod-
els:
●
ā
w
< 2.5 m/s
2
NOTE
It is mandatory to specify the hand-arm vibra-
tions, even where the values do not indicate
any danger, as in this case.
Vibrations to which the body (legs) is
exposed
The following values to which the body (legs)
is exposed only apply to trucks with a folding
platform that the operator is standing on.
The following value is valid for trucks with a
capacity of 1400 kg and 1600 kg:
●
ā
w,zF
= 0.60 m/s
2
Uncertainty K = ± 0.18 m/s
2
The following value is valid for trucks with a
capacity of 2000 kg:
●
ā
w,zF
= 0.97 m/s
2
Uncertainty K = ± 0.29 m/s
2
The value complies with Harmonised Europe-
an Standard EN 13059 (Safety of industrial
trucks — methods for measuring vibration).
CAUTION
The value expressed above can be used to compare
forklift trucks of the same category. It cannot be used
to determine the operator's daily exposure to vibra-
tions during real operation of the truck; these vibra-
tions depend on the conditions of use (floor condi-
tions, method of use etc.) and therefore daily expo-
sure must be calculated using data from the place of
use.
Declaration of conformity in
accordance with the Radio
Equipment Directive
2014/53/EU
The manufacturers of the radio equipment in-
stalled in the industrial truck declare that the
radio equipment corresponds to the Radio
Equipment Directive 2014/53/EU. The decla-
rations of conformity can be viewed at the fol-
lowing Internet address:
https://www.still.de/eu-declarations.html
Safety
2
Vibrations
2145758043484 EN - 11/2021 - 08
To Next Page
Loading...
