Automatic speed reduction with
forks raised above the safety
sensors
As indicated in the safety devices chapter,
(see
⇒
Chapter "Location of safety devices",
Page 23 ), the truck is equipped with:
●
500-mm sensor Automatic speed reduction
with forks raised approximately 500 mm
above the ground.
●
1700-mm sensor Automatic reduction of
driving speed with forks raised approxi-
mately 1700 mm above the ground.
NOTE
Automatic reduction of the truck driving speed
remains active if the forks are lowered below
the sensor height (500 mm and 1700 mm)
during travel (drive throttle turned).
In this case, to eliminate automatic driving
speed reduction, fully release the drive throttle
after lowering the forks below the sensor
height (500 mm and 1700 mm). At this point, if
the throttle is turned again the truck will contin-
ue without the previous automatic speed re-
duction.
Picking up the load
Load pick up from the ground
– Approach the load with caution and with as
much precision as possible.
– Lower the forks and the straddles so that
they can easily be inserted into the pallet.
– Slowly insert the forks at the centre of the
load to be lifted.
CAUTION
Insert the fork without bumping into either the shelv-
ing or the load.
– Insert the forks as far as possible below the
load. If possible, the forks should be inser-
ted far enough in that the load is resting
Use
4
Moving the load
10745758043484 EN - 11/2021 - 08
To Next Page
