against the fork carriage. The load centre of
gravity must be centred between the forks.
DANGER
Pay attention to the part of the forks protruding
from the load to be lifted.
Do not strike the wall, the shelving or other loads
and/or objects behind the load to be picked up.
– Lift the load a few centimetres from the
ground and read the "Transporting loads"
section.
Load pick up from shelving.
– Approach the shelving at moderate speed.
Use the drive control throttles to gradually
slow down and stop the truck perpendicular
to the shelving with the tiller in the braking
position.
– Check that there is sufficient space be-
tween the forks and the shelving.
– Raise the forks until you reach the correct
fork insertion height.
– Move the truck slowly forwards to insert the
forks into the load.
CAUTION
Insert the fork without bumping into either the shelv-
ing or the load.
Use
4
Moving the load
108 45758043484 EN - 11/2021 - 08
To Next Page
