– Insert the forks as far as possible below the
load. If possible, the forks should be inser-
ted far enough in that the load is resting
against the fork carriage. The load centre of
gravity must be centred between the forks.
DANGER
Pay attention to the part of the forks protruding
from the load to be lifted.
Do not strike the wall, the shelving or other loads
and/or objects behind the load to be picked up.
– Raise the load a few centimetres until it is
resting fully on the forks. If the load is stable
and secure on the forks, proceed with the
following steps. In the event of uncertainty
and/or a load that is not properly secure or
stable, lower the forks and place the load
back on the shelving.
– Put the tiller in the driving position. Look be-
hind to check that the way is clear. Turn the
throttle in the direction of travel towards the
operator and drive very slowly and carefully
in a straight line away from the shelves.
Brake gradually.
– Check that there is sufficient space be-
tween the forks and the shelving.
Use
4
Moving the load
10945758043484 EN - 11/2021 - 08
To Next Page
