positioning it on the previously prepared ex-
ternal roller unit.
– Hook the battery at the two points (8) with a
sling or chain.
– Lift the battery and remove it.
DANGER
Use a crane with a suitable lifting capacity for the
weight of the battery. Lifting operations must be
performed by qualified personnel. DO NOT stand
within the crane's radius of action or near the truck.
Do not stand in the danger area beneath suspen-
ded loads. Use NON METALLIC slings. Make sure
that the lifting capacity of the slings is suitable for
the weight of the battery. The slings must be pulled
vertically. To prevent short circuits, it is recommen-
ded that batteries with polar terminals or unprotec-
ted connections be covered with a rubber mat.
– Change the battery and refit it by following
the above steps in reverse order.
– When installing the new battery, be particu-
larly careful during the battery insertion
stage. Push the battery inwards, sliding it
along the rollers on the truck and position-
ing it on the previously prepared external
roller unit.
DANGER
"Danger of crushing hands" between the battery
frame and the battery lock lever. Do not put your
hands in zone "A" and keep all other parts of the
body, such as the head, out of the way when insert-
ing the battery. The operation must be performed
by a single operator. The operator must follow the
operating instructions given in this section, position-
ing himself on the same side as the battery side-re-
moval roller unit.
CAUTION
To decide which type of battery to use, check the
battery characteristics provided in the "TECHNICAL
DATA" chapter.
2028
8
8
Maintenance
5
Maintenance as required
13345758043484 EN - 11/2021 - 08
To Next Page
Loading...
