Protective covers fastened with screws. Do
not use the truck without the protective cov-
ers.
Operator on the platform presence sensor (if
present). Only ride-on driving is allowed with
the platform lowered.
Anti-shearing protective guard. Available in
a metal grille version or a transparent plastic
material version.
"500-mm" sensor. Automatic speed reduc-
tion with forks raised approximately 500 mm
above the ground.
"1700-mm" sensor. Automatic reduction of
driving speed with forks raised approximate-
ly 1700 mm above the ground. With strad-
dles raised, the sensor reaches a height of
approximately 1800 mm.
5
6
7
8
9
Automatic truck braking when the tiller is re-
leased by the operator
Horn. Used to indicate the presence of the
truck during travel.
Combi tiller clasp closure sensor. If the clasp
is not closed properly, the truck will not
move.
Fork stop latches. Used to adjust the dis-
tance between the forks. Do not use the
truck with the latches open (EXP only).
Screw that acts as a mechanical stop. The
screw prevents the unintentional extraction
of the forks. Do not unscrew or remove the
stop. Do not use the truck if the mechanical
stop is missing (EXP only).
10
11
12
13
14
Safety
2
Safety devices
24 45758043484 EN - 11/2021 - 08
To Next Page
Loading...
