NOTE
The forks must be in the lowered position
when the truck is started.
If the forks are in a raised position when the
truck is started, the DLC 3 icon is displayed.
A yellow triangle appears on the display.
The display indicates that the forks must be
lowered. The arrow points downwards.
During work
The forks must be lowered regularly when the
truck is in use.
If the forks remain in the raised position for
more than four hours:
– A warning sound is emitted.
– The DLC 3 icon is shown on the display.
– A yellow triangle appears on the display.
– On the display, the arrow points downwards
only.
– The forks must be lowered immediately.
If the operator does not immediately lower the
forks, travel speed and lifting speed are auto-
matically reduced.
CAUTION
The display does not work any more.
Do not continue to operate the truck. Contact your
service centre to replace the display.
In the event of error code L354
Error code L354 (1) may be displayed on the
screen.
It is therefore necessary to check that:
●
There is nothing obstructing the field be-
tween the two sensors. The field may be
obstructed by an object.
●
The sensors are clean.
After these checks, the forklift operator must
restart the truck.
If the error code L354 is displayed again after
the restart, contact the service centre.
In the event of error code T526
Error code T526 is displayed on the screen to
warn the operator that the sensor battery is
discharged. Contact a service centre author-
ised by the manufacturer.
Overview
3
Options and variants
7145758043484 EN - 11/2021 - 08
To Next Page
Loading...
