●
Tilt the tiller, then release it. Check that the
tiller automatically returns to the vertical po-
sition.
●
Test that the truck brakes and stops when
the tiller is released while driving.
●
Check that the truck brakes and stops when
the tiller is pushed all the way down while
driving.
●
Check that the emergency shutdown handle
is operating correctly. Carry out the test
when travelling towards the forks.
●
Check that the anti-crush/operator anti-
crush protective device is operating correct-
ly.
●
Check that the brake is operating correctly.
●
Test that the electromagnetic brake works
effectively.
●
Check that the battery harness is in good
condition.
●
Check and test the battery electrolyte level
and density as indicated in the battery in-
structions.
●
The operator must be qualified to drive the
truck. The operator must be able to reach
the controls and operate them (especially
the anti-crush protective device). Do not ob-
struct access to the controls.
●
Check that the side protection panels are in
good condition and are operating correctly
(EXV-SF only).
●
Visually check that the operator platform is
in good condition and that it is operating
correctly (EXV-SF only):
- Climb onto the operator platform and turn
on the truck.
- Test that the truck goes into forwards/
reverse travel using the control throttle.
- Climb down from the step plate and visual-
ly check that the operator platform automat-
ically moves to a rest position, tilted slightly
upwards.
- Stand to the side of the truck and make
sure that the area in front of and behind the
truck is clear.
- Using a boom, tilt the tiller without turning
and slightly rotate the control throttle to-
wards the forks. Repeat the sequence, turn-
ing the throttle in the opposite direction. In
both cases, test that the truck remains at a
standstill. The truck must NOT move.
- Push the platform upwards. Push the op-
erator platform slightly to check that it auto-
matically moves into a vertical, fully closed
position. Caution: danger of crushing
hands!
- With the platform in a vertical position and
the side panels open, check that the truck
does NOT function!
●
Check that the fork stop latches are in good
condition, operating and positioned correct-
ly (EXP only).
●
Check that the fork stop latches are proper-
ly and completely closed (EXP only).
●
Check that the forks are locked and cannot
move accidentally (EXP only).
●
Check for the presence and the correct po-
sitioning of the mechanical stop that pre-
vents the unintentional extraction of forks
(EXP only).
Use
4
Checks and actions prior to commissioning
8945758043484 EN - 11/2021 - 08
To Next Page
Loading...
