– Tighten the wheel nuts to full torque (see
corresponding paragraph).
– When changing wheels with tyres, inflate to
the prescribed pressure.
Change brake system liquid
ENVIRONMENT NOTE
Please handle liquids and lubricating oil in ac-
cordance with instructions.
NOTE
please contact your authorised dealer for drain
and change brake system liquid.
●
Capacity: approximately 0.3L.
CAUTION
Use a mistake and mixed with the brake liquid can
cause the brake system seal unit rusty, even to the
extent the brake out of order , serious consequences
and so on.
Fill up the hydraulic oil
– Unscrew the oil cap (1)assembly.
– Fill up with hydraulic oil through the oil inlet:
90L for mast below 4500mm mast
95L for mast exceeding 4500mm mast
– Use the dipstick to check the oil level. The
oil level should reach the upper marking on
the dipstick.
– Close the bonnet.
– Start the engine and run it for a while.
Check the oil level again. Check the seals.
Maintenance
5
Maintenance service
14560118011601 EN - 09/2020
To Next Page
Loading...
