– Slacken off the fastening bolts and washers
on the cover assembly, then remove the
cover assembly.
– Slowly pull out the cover assembly so that
the oil flows back into the tank.
– Unscrew the suction filter (2) and return fil-
ter (3) from the cover assembly.
– Screw in the new intake filter until tightened.
– Refit the cover assembly to the frame using
the fastening screws.
– Refit the bracket and pedal pad.
– Refit the engine cover.
Replacing the breather filter
ENVIRONMENT NOTE
Please handle liquids and lubricating oil in ac-
cordance with instructions.
– Open the bonnet.
Maintenance
5
Maintenance service
14760118011601 EN - 09/2020
To Next Page
