4 Operation
Lighting
6219_003-231
Warning zone light (variant)
WARNING
Danger of damage to eyes from
looking into the warning zone light.
Do not look into the warning zone light.
Adjust the warning zone light so as
not to dazzle bystanders or the driver
when climbing in and out of the truck.
The warning zone light is mounted on supports
on the overhead guard such that it is not
affected by jolts and vibrations. It projects a
light bar next to the truck on both the left-hand
side and right-hand side of the truck. These
light bars indicate the danger areas to the
sides of the truck while in operation. See the
section entitled "Danger area" in the chapter
entitled "Handling loads".
The warning zone light switches on and off
again together with the truck.
If the truck has StVZO (German Road Traffic
Licensing Regulations) equipment, the warn-
ing zone light can be switched on and off via
the display-operating unit.
– To do this, press the corresponding softkey.
NOTE
If the truck is to be operated on public roads,
the warning zone light must be switched off.
– Before using the tr
uck, make sure that the
warning zone light is
working and has been
adjusted correctly.
The distance from the light bar to the truck
must be between 70...75 cm.
– To adjust the warning zone light, see the
section entitled "Adjusting the warning zone
light" in the chapter entitled "Preserving
operational readiness".
When ordering the truck, you
can choose
between a blue or red warning z
one light.
128
56368011531 EN - 06/2019 - 02
To Next Page
Loading...
Need help?
General
