Operation 4
Efficiency and drive modes
Efficiency and drive modes
Blue-Q (variant)
Functional description
The Blue-Q efficiency mode affects both the
drive unit and the activation of the additional
consumers, and reduces the truck's energy
consumption. Blue-Q can be switched on and
off via a softkey.
If efficiency mode is switch
ed on, the acceler-
ation behaviour of the truc
k changes to make
acceleration more moderat
e.
When travelling at low speeds, normally when
manoeuvring, no reduction is noticeable even
if efficiency mode is switched on. For moder-
ate speeds from approx. 7 km/h, acceleration
is gentler. Therefore, on distances of up to
approx. 40 m, lower speeds are reached than
would be the case if the efficiency mode was
not activated. As in "STILL Classic" mode, the
maximum speed is 20 km/h.
has no influence on:
• Maximum speed
• Climbing capability
• Pulling force
• Braking characteristics
Effects on additional consumers
The following table shows the specific conditions that cause certain auxiliary devices to shutdown
when Blue Q is activated. The additional consumers available depend on the truck equipment.
Shut-off Seat switch
Truckisstationary
Drive direction
Front working
spotlight*
XX
Reverse > 3 km/h
Rear working spotlight*
XXForwards
Roof spotlight*
XX>3km/h
Headlight*
XX
-
Front wiper
X X Reverse > 3 km/h
Rear wiper
XXForwards
Roof wipe
r
XX
-
Seat heater
X
--
563
68011531 EN - 06/2019 - 02 129
To Next Page
Loading...
Need help?
General
