STM SatLink 2000 - Page 101

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 100 (160)
Licenses for SW options:
PEP-TCP
QOS-4
Max Mesh Connections: 8
Mesh Satlink VSAT is autonomous regarding the mesh operation, and there is no need of setting up any
configuration parameters. The mesh operation can be disabled by configuration if desired.
The available mesh CLI commands are listed in the table below.
CLI commands Available in
Boot
SW
Available in
Application
SW
User
Privilege
Level
dvb mesh enable x
dvb mesh disable x
dvb brx show x
dvb mesh show [–config
|
-links
|
-routes
|
-stat] x
• dvb mesh enable, dvb mesh disable
These CLI commands enable and disable mesh capability of the VSAT. By disabling the mesh capability,
the VSAT is moved to star operation. Note: for a change of this parameter to have effect, the VSAT must
be logged off and logged on again.
• dvb brx show
This command displays the physical layer status.
# dvb brx show
Satellite (DVB) Burst Receiver Status
-------------------------------------
State : Fine Sync
RF to B-band offset : -5622 [Hz]
AGC Status : enabled
AGC Gain (relative) : 41 [dB]
Rx Lband Input Level : -50 [dBm]
#
The parameters displayed by this command are explained in the table below.
Field Explanation
State
The state of the physical layer. Possible values are:
- Initialisation (burst receiver in initialisation state)
- Wait for CSC (the VSAT is trying to acquire its own
transmitted logon burst)
- Coarse Sync (the burst receiver is synchronized with
more than +/- 52 ticks timing error)
- Fine Sync (the burst receiver is synchronized with less
than +/- 52 ticks timing error)