STM SatLink 2000 - Page 20

SatLink VSAT User Guide
Publication no. 101557
Copyright © 2009 – STM Group, Inc.
Page 19 (160)
not use automatic VSAT configuration then additional VSAT parameters ight have to be configured
during installation.
6.2.1 Receiver Parameter Configuration
The STM SatLink VSAT is normally pre-configured to be used together with the STM SatLink 403x
transreceiver. But, it is possible to configure the STM SatLink VSAT to operate together with other
transreceivers than SatLink 403x. The list of LNBs that can be used with the STM SatLink VSAT are
listed in Table 5
1) Click on the Satellite option in the SatLink VSAT home page.
Figure 16 : Configuring Receiver Parameters
2) Configure the Receiver parameters as shown in the following table.
Parameter Description
Auto Start
• ON
• Off
Specific for the receiver. When set to "ON" the VSAT will automatically acquire the
forward link. It is recommended to always set this to ON for normal operation. Please
always restart the VSAT after saving configuration when having set auto start to ON.
LNB Type Specifies the LNB type with which the VSAT is configured.
Index Table index [0 – 9]. The SatLink VSAT can store up to 10 forward link entries and the
table index is used to identify a single entry.
Priority Forward link search order [0 – 1]. Search is started for priority 0 first and ends with
priority 1.
Symbol Rate (Msps) The forward link symbol rate in Msps.
Frequency (Ghz) Forward link frequency [kHz].
Mode Enter the valid modes :
• DVB-S
• DVB-S2
PopId Population ID to use for forward link acquisition. The STM SatLink VSAT will select
which group in the DVB-RCS system it belongs to based on the configured population