Here you have to insert the correct COM number. Usually when the cable is inserted on the USB
port, the computer should create a new “virtual” serial port with a new COM number, you
should check in the device manager of Pc and insert this number, then select “OK” button.
When you find the right COM port, you should see the screen shown in Fig 5.3 that show you in
the main window the system information.
Fig. 5.3 – Information page of Stonex Assistant
From the showed information you can understand about: the battery level, the firmware
version of GNSS board, the antenna information, the firmware of radio and gprs internal
device, the free disk space and the current working and datalink setting.
To Next Page
Loading...
