Storz D-ACTOR 200 - Page 8

19 620 02 0117
8
General Safety Information
The use of accessories or cables that are not authorised by the manufacturer can
result in increased interference emissions or reduced resistance to interference
emissions by the device.
The D-ACTOR
®
200 is not allowed to be positioned immediately next to or jointly
with other devices. If the operation near or jointly with other devices is required, the
D-ACTOR
®
200 must be tested in that particular environment to ensure operation
accordingtotechnicalspecication.
The system must only be connected to properly earthed and correctly installed
shockproof sockets!
Set-up and operation
There are ventilation slits on the left side of the device which must not be covered by
other objects.
• Check that the system is in perfect working order before each use. Read about this in
Chapter 4.8 funCtiOnal CheCks.
• Never cover the device when in use!
• Make absolutely sure that no liquid can seep into the system housing or
handpiece.
Storage and transport
Incorrect storage and transport can result in damage to the device and device failure.
• Make sure that no cables are crushed or sheared.
Disposal
• Comply with national disposal regulations when disposing of the D-ACTOR
®
200
or individual components.
• Comply with the relevant information in the operating manuals for the additional
devices.