Storz D-ACTOR 200 - Setting parameters; Coupling the handpiece; Triggering pulses

19 620 02 0117
56
Operation
4.10.1 Setting parameters
Treatment should always start at a low energy level. This also applies to resuming
treatment after an interruption. The pulse energy should be increased gradually
during treatment. The low levels are used less for therapy and more for familiarising
the patient.
• Select a low energy level and frequency (see Chapter 4.2 OperatiOn).
NOTE
The selection of energy levels is based on the medical opinion of the doctor
administering treatment. The maximum energy level used during treatment
must not cause the patient undue pain under any circumstances.
4.10.2 Coupling the handpiece
D-ACTOR
• Applyasufcientamountofcouplinggeltothepatient’sskininthetreatment
area and to the transmitter.
• Avoid excessive pressure of the transmitter to the patient‘s skin. Excessive pressure
is not needed for the success of the treatment.
V-ACTOR
• Applyasufcientamountofmassageoiltothepatient’sskininthetreatmentarea
and to the V-ACTOR II transmitter.
4.10.3 Triggering pulses
Once all necessary preparations have been taken, it is possible to start the treatment.
• Make sure that the pulse counter is at zero and a low energy level has been set.
• Press the trigger button on the handpiece.
– Pressing the trigger button anew stops the pulse release.
4.10.4 Functions overview of the handpiece D-ACTOR
For the total overview of the functions and the description of the handpiece please
refer to the seperate Operating Manual handpieCe d-aCtOr.