Storz VITOM EAGLE - Product Disassembly; Disassembly Procedure

Disassembly
Instructions for use • VITOMEAGLE • TVA900_EN_V1.0_05-2023_IFU_CE-MDR 29
7 Disassembly
7.1 Disassembling the product
1. Switch off the products.
2. To disconnect the VITOMEAGLE from the power supply, remove the VITOMEAGLE power
cable from the power supply.
3. Disconnect the holding system from the power supply.
4. Disconnect the IMAGE1S and the 4U-LINK from the power supply.
5. Wait until the VITOMEAGLE has completely cooled down.
6. Remove and dispose of the sterile drapes.
7. Remove the camera head cable from the 4U-LINK and switch the light source to standby mode.
8. Remove the IMAGE1PILOT from the holding system.
9. The VITOMEAGLE can be left on the holding arm or dismounted for storage.