Workstation Requirements 3-6
4 Operating and Maintaining the Printer
Starting the Printer 4-3
Loading Model and Support Cartridges 4-5
Producing 3D Prints 4-6
Preparing the Printer 4-6
Starting Printing 4-7
Printer Interface Color Key 4-8
Printing Indicators 4-9
Resuming Production After Printing has Stopped 4-10
Changing the Printing Material 4-13
Changing Model Materials Without Flushing 4-18
Advanced Settings 4-21
Keeping the Printer in Idle Mode 4-24
Setting the Cartridge Expiration Alert 4-25
Shutting Down the Printer 4-27
Maintaining the Printer 4-31
Routine Maintenance Schedule 4-31
Maintenance Counters 4-32
UV Lamp Check 4-34
Pattern Test 4-34
Backing up the Printer Configuration 4-37
Improving Print Quality 4-38
Cleaning the Print Heads, UV Lamp Glass, Roller and Wiper 4-38
Cleaning the Roller Waste Collector and Inspecting the Roller Scraper 4-43
Replacing the Roller Scraper 4-47
Aligning the Print Heads 4-49
Cleaning the Print-Head Splash Shield 4-55
Optimizing (Calibrating) Print Heads 4-57
Replacing Print Heads 4-66
Testing and Calibrating the UV Lamps 4-76
Calibrating the Load Cells 4-85
Flushing the Print-Block Heater 4-86
Replacing the Waste-Pump Tubes 4-91
Replacing the Material Filters 4-99
Replacing the Odor Filter 4-101
Replacing the UV Lamps 4-102
Improving Color Uniformity of X-Walls 4-111
Dynamic Nozzle Test 4-123
Built-in Tests 4-125
DOC-28000 Rev. I iv
To Next Page
Loading...
