Stratasys Objet500 - Page 158

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-27
3. Followtheinstructionsonthewizardscreens,andselecttheconfirmation
checkboxes.
Figure6-24Headcleaningprocedure—wizardscreen
4. ClickNext.
Theprinterpreparesforyoutocleantheprintheads.
5. Whenthefollowingscreenappears,openthecover.
Figure6-25Headcleaningwizard—steps5–11
Warning: Hot Surface
Theprintheadorificeplates(bottomsurface)maybehot.Donottouch
themwithyourbarehands,andproceedwithcaution.
6. Placethemirroronthebuildtray.
7. Putonthegloves.
Caution
Uncuredprintingmaterialontheprintheadsmightcauseskinirritation.
Usedisposablecleaningglovestoprotectyourhands.
8. Soakthecleaningclothwithalcohol.