Stratasys Objet500 - Page 161

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-30
4. Makesurethatthebuildtrayisempty,andclosetheprintercover.
ConfirmthisinthewizardscreenandclickNext.
Figure6-29WiperCleaning—step4
5. Whenthefollowingscreenappears,openthecover.
Figure6-30WiperCleaningwizardduringsteps6–10
6. Putonthecleaninggloves.
7. Usingagenerousamountofalcoholonthecleaningcloth,removeany
materialremainingonthewiperandthesurroundingarea.