Stratasys Objet500 - Page 176

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-45
7. Inthefollowingscreen,makesureOptimize all print headsisselected,
andclickNext.
Figure6-56Procedureselectionscreen
8. Selecttheprintingmodeforwhichyouwanttooptimizetheprintheads
andclickNext.
Figure6-57Printingmodeselection
IfyourprinterissettoprintinSinglematerialmode,onlytheHigh Speed
andHigh Qualityoptionsareenabled.
IfyourprinterissettoprintinDigitalMaterialmode,onlytheDigital
Material opitonisenabled.