Stratasys Objet500 - Page 179

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-48
14.Afterconfirmingalloftheitemslistedinthewizardscreen,clickNext.
Printingmaterial(resin)isjettedfromeachheadanditsweightis
automaticallyrecorded.Thisprocessisrepeatedforeachprintingmode,
afterwhichthefollowingscreenappears.
Figure6-63Emptyingtheresincontainer
15.Carefullyremovetheresincontainerfromthescaleandemptyitintothe
purgeunitintheprinter.Thenreturnthecontainertothescale.
Caution: The resin in the container is uncured
l Topreventcontactwithskin,wearneopreneornitrilegloves.
l Disposeofuncuredresininaccordancewithapplicableregulations.By
emptyingthecontainerintothepurgeunit,theresinisstoredinthe
printer’ssealedwastecontainer.
16.ClosetheprinterandclickNext.
Theprintercurestheremainingresininthecontainer.
17.Whenthefollowingscreenappears,removethescaleandcleanthebuild
tray.
Figure6-64Remove the scaleconfirmationscreen