Stratasys Objet500 - Page 185

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-54
RemovingtheDefectiveHead
10.Ontheprintblock,releasetheupperandlowerscrewsthatsecurethe
printheadintheblock.(Ifnecessary,youmayuseascrewdrivertoloosen
thescrews.)
Figure6-72Releasingthelockingscrews
11.Pressdownontheupperandlowerlockingscrewstoreleasetheprint
head.
Figure6-73Releasingtheprinthead