Stratasys Objet500 - Page 187

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-56
14.Makesurethatalongwiththehead,youremovethetworubberO-ring
seals.
Figure6-76O-ringsealsontheprinthead
Important
Ifthesealsarenotremovedwiththehead,theyareprobablystucktothe
printblockhousing.Ifso,removethem.
Figure6-77MakingsuretheO-ringsarenotstucktotheprintblock