Stratasys Objet500 - Page 208

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-77
Accessing
Built-inTests
ToopentheBuilt-inTestsscreen,dooneofthefollowing:
•FromtheOptionsmenu,selectBuilt-InTests.
•PressCtrl+Alt+B.
Figure6-117SelectingBuilt-In TestsfromtheOptionsmenu
TheBuilt In Testsscreenlistspre-configuredtests,groupedbycomponent
categories.Inthisscreen,youselectandruntests,andtheresultsare
displayed.
Figure6-118Built In Testsscreen