Stratasys Objet500 - Page 209

Objet500 User Guide 6 Operating and Maintaining the Objet500 3DPrinter
DOC-07027 Rev.E 6-78
TestList
Test Name
Thiscolumnlistsallofthetests,togetherwithselectioncheckboxes.
Clickthecheckboxestoselectthetestsyouwanttorun.Toremovea
selection,clickthecheckboxagain.Toquicklyselectallofthetestsina
componentcategory,usetheGroupdrop-downlistatthebottomofthe
screen.
Group
Thiscolumnshowsthecomponentcategoriesforeachtest.
ThistellsyouwhichtestsarerunwhenselectingacategoryfromtheGroup
drop-downlistatthebottomofthescreen.
Status
Thiscolumnshowstheresultsofeachtestafteryourunit:
Testsuccessfullycompleted.
Testfailed.
Unknownresults.(Thetesthasnotbeenrunyet.)
TestSelectionArea
IntheTest Selectionarea,atthebottomofthescreen,youcanquicklyselect
orde-selecttestsbytheircharacteristics:
All Clicktoselectallofthetestsinthelist.
None Clicktode-selectallofthetestsinthelist.
Unknown Clicktoselectalltestthathavenotbeenrunyet(Status=?).
Group Usethismenutoselecttestsbycomponentcategory.
Selection Set Usethismenutoselectapre-configuredsetofteststorunat
specifiedtimes(computerstartup,beforeprinting,etc.).
RunningBuilt-inTests
Toruntheselectedtests:
➢ Click .
Afteryourunatest,theSaveandViewcommandbuttonsareaddedto
theBuilt In Testsscreen.