Strobel 441-1 - Parameter and Functions F-715 (Class 441-2); Parameter and Functions F-760 (Class 441-2)

42 MA_441-1-2_A1_180830_en
4.17.4 Parameter and Functions F-715 (Class 441-2)
Function Parameter
Selection of processing via parameter F-715 F-715
With the Parameter F-715 you can decide if you want to use a sewing program
for pairwise shoe processing or single shoe processing.
F-715 = 0
In this mode, e.g. the sewing program 02 for a right shoe
and the sewing program 03 for a left shoe is repeated in
continuous sequence.
F-715 = 1
In this mode, e.g. the sewing program 02 for a right shoe
is repeated until you manually switch to the next sewing
program 03 for a left shoe.
4.17.5 Parameter and Functions F-760 (Class 441-2)
Function Parameter
Setting synchronized differential feed F-760
With this parameter, the synchronisation of the differential transport can be
finely adjusted if the material pairings have different friction values.
The factory setting is set to value "6".
In the factory setting "6" our off-sewing material is transported synchronously
between feed- and front cup.
If the materials have different values of friction, we have the option of fine
adjustment of the differential feed to ensure always synchronized operation.
Value 0 – 5 = More transport by the front cup
Value 6 = factory setting
Value 7 – 10 = Less transport by the front cup
After entering the code number "3112" for the supplier level:
- Select parameter F-760
- Press the "E" key
- Enter the value or correct the value up or down
- Press the "P" key