Strong SRT 4922A - Page 17

17
English
6. Operation
6.1
Getting Started
▣ Blind Scan <Figure 6.1.10>
1. Select the satellites you want to search by pressing the OK button on the remote.
2. Press , to set the “Polarization” and “Scan Mode” options.
▪ TP: Select TP Frequency
▪ Polarization: Select among All / Vertical / Horizontal
▪ Mode: Select among All / Free / TV
▪ SCAN: Begin channel search of the selected satellites.
Figure 6.1.10
▣ Manual Scan <Figure 6.1.11>
1. Select a transponder.
2. To change a transponder’s information (Frequency, Symbol Rate), use the NUMERIC buttons.
3. To add a new transponder, press the GREEN button.
4. To delete a transponder, press the YELLOW button with the cursor next to the Frequency
parameter.
5. To search a transponder, set its different parameters and press RED button.
[2013.01.04]SRT4922A 매뉴얼_english_AUS.indd 17 2013-01-04 오후 4:49:47