21
6.1 Getting Started
(When the DiSEqC Motor parameter is set as USALS <Figure 6.1.6>)
▪ Sat Degree: Satellite location.
▪ Antenna Position: Press OK.
▪ Goto Reference: Move the dish to the reference 0 position.
▪ Antenna Longitude: Your longitude at present.
▪ Antenna Latitude: Your latitude at present.
? Note: You need to know what LNB you are using to correctly
set the L.O. (local oscillator) frequency.
? Note: You need to understand how your receiver is connected
to properly set the 22KHz and DiSEqC.
Figure 6.1. Figure 6.1.7
6. When you are done, press the EXIT button.
To Next Page
Loading...
