Strong SRT 7040 - 8. A.1 TROUBLESHOOTING

28
WARNING: NEVER power o the receiver or remove the USB device during the software update process.
Doing so might cause irreparable damage to your receiver and will void your warranty.
NOTE: In certain instances it can be advised on the website to upgrade the unit with the Maincode option
in stead of Allcode.
The bootlogo and Radioback are for Strong internal use.
7.3.6 Dump channel list
7.3.6.1 DB Management
This menu allows you to save and reload the channel Data Base of your receiver from/to a USB-device. This
very convenient feature enables you to save your personal settings like Channel-, Favourite-, Sat- and TP-lists
on an USB storage device and load them back to the receiver later.
Write to USB Dump Channel list
Select Update Mode, then Dump channel list and Start and press OK to make a backup of the data base,
including channels and user set data. An.udf le with the current time, date (day, month, year), will be
created on the USB device. When the database has been successfully stored a message will be displayed on
screen. Press  to leave the menu.
7.3.6.2 Load from USB Update channel List
Select Update Mode, then Update channel list. Select the le at Upgrade File you want to restore to.
Use tu for displaying the available database les (if any stored before). The.udf les are shown with their
built time, date (day, month, year) Select the le you want to load and then select Start to load the le. When
the database has been successfully loaded the receiver will reboot and switch automatically to the rst
stored channel.
Remove USB safely Use this option to safely remove your USB device from the unit. It will prevent loss of
data and prevent hardware damage to such a device. This procedure is comparable working with a personal
computer.
8. A.1 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Please check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please contact
your local Service line or STRONG dealer. Alternatively, you can send a support mail via our website: www.
strong.tv. NEVER open or disassemble your receiver. This may cause a dangerous situation and will void the
warranty.
Problem Possible cause What to do
The standby indicator
does not light up
The mains lead is unplugged/the
multipoint connector is switched o.
Check the mains lead/switch the
multipoint connector on.
No picture The receiver can't receive signal. Check the antenna cable, replace the
cable, or connect the cable to the
receiver tightly.
Incorrect values of some tuner
parameters.
Set the values of tuner parameters
correctly in the Installation menu.
Wrong direction of the dish. Check signal strength and adjust your
dish correctly.