29
Problem Possible cause What to do
No picture or sound on
TV
The input is not selected on your TV. Switch to the correct TV input.
The TV is not connected to the mains.
Bad cable connection.
Check the mains lead.
Firmly plug in the cables between the
receiver and TV.
Audio muting. Press the ! button.
TV power o. Turn the TV on.
Scrambled channel
message
The channel is scrambled. Select an alternative channel.
No response to remote
control
The receiver is o. Plug in and turn on the plug.
The handset is not aimed correctly. Aim the handset at the IR sensor.
The IR sensor is obstructed. Check for obstructions.
The handset batteries are exhausted. Replace the handset batteries.
Password forgotten The default password is 0000 Contact the local Service Hotline or
send an email to our support via www.
strong.tv
The external USB HDD
does not start.
The power consumption is too high. Connect an extra power supply adapter
to your USB HDD device.
The receiver switches to
standby automatically.
The Auto Standby function is
activated and has reached the set
time (default 3h).
Set the power down time or disable it
in the System Setup > Auto Standby
menu.
9. A.2 SPECIFICATIONS
Demodulator
Demodulation: QPSK, 8PSK
Input symbol rate: DVB-S QPSK: 2 ~ 45 Ms/s
DVB-S2 8PSK/QPSK: 2 ~45 Ms/s
FEC decoder: Auto, 1/2, 2/3, 3/4, 5/6, 7/8 in DVB-S mode
1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10 in DVB-S2 mode
3/5, 2/3, 3/4, 5/6, 8/9, 9/10 in 8PSK mode
Video Decoder
Video Format Mpeg1/2, H264 max 1080x1920...)
Input rate: Max. 20Mbit/s
Aspect ratio: 16:9, 4:3 Pan&Scan, Letterbox, Auto.
Video resolution: 480i, 480p, 576i, 576p, 720, 1080i, 1080p, 50/60Hz.
Audio Decoder
Audio decoding: MPEG-1/2 Layer 1 & 2, AC3, Dolby and Dolby Plus
Audio mode: Mono L/R, Stereo,
Audio Support: E-AC3, Dolby Digital, Dolby Digital Plus*
Sampling rate: 32, 44.1, 48 kHz
*Dolby Digital, Dolby Digital Plus and the double-D symbol are registered trademarks of Dolby Laboratories
Tuner
Type1: F Type, IEC169-24, Female
Input frequency range: 950 – 2150 MHz
RF impedance: 75 Ohm unbalanced
Signal level: -65 to -25 dBm
To Next Page
Loading...
