Strong SRT 8222 - 3.4 Connecting to a Digital Audio Amplifier with S;PDIF; 3.5 Connecting to a Digital Audio Amplifier and TV using HDMI; 3.6 Connecting to Ethernet; 3.7 Connecting a USB storage device

3.4 Connecting to a Digital Audio Amplier with S/PDIF
Fig.7
By connecting your receiver to a digital amplier or home theatre system, you can enjoy the best
possible sound quality and multi-channel audio (depending on broadcast) up to Dolby Digital.
Connect your Digital Audio Amplier or home theatre system with a suitable cinch cable to the S/
PDIF connector on the back of the receiver.
3.5 Connecting to a Digital Audio Amplier and TV using
HDMI
Fig.7
By connecting your receiver to the latest digital ampliers or home theatre systems with HDMI
connections, you will enjoy the best possible sound quality and multi-channel audio (depending
on broadcast), up to Dolby Digital Plus. Connect the HDMI output of the receiver to an input of your
amplier, and then connect the HDMI output of the amplier to your TV set. Select the correct input
on your amplier to watch and listen to programmes.
3.6 Connecting to Ethernet
Fig.7
Connect a CAT5 cable (or higher quality) to the LAN (RJ45) connector of the unit and the other end to
an existing switch, router or modem. The default setting is Auto (DHCP) for automatically obtaining
IPs and DNS. Select DHCP O in Menu> System>Network Setting>IP setting to enter your own settings
if required. When setting up manually, you need to provide a unique IP address, Netmask, Gateway
and DNS for your receiver. Refer to the manual of your router or modem to setup properly. signalling
will give momentary status of connection, like cable unplugged, local network or internet.
3.7 Connecting a USB storage device
Fig.8
NOTE: We recommend the use of a hard disk drive USB 2.0 or higher for recording
and play back of TV events.
For proper functioning of Timeshift and recording functions, a fast USB device (such as a hard
disk drive) is needed. Interrupted playback or a distorted picture during playback or Timeshift are
indications for a low device speed. STRONG cannot guarantee proper functioning of recording and or
Timeshift functions with all USB devices.
3.8 Connecting a secondary TV.
The antenna signal is looped-through to use with another TV (either Analogue or Digital) to share the
same antenna.
8