EasyManuals Logo

Strong SRT 8222 User Manual

Strong SRT 8222
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
1.0 INTRODUCTION
1.1 Safety Instructions
Read all of the instructions before operating the device. Keep these instructions well for later use.
Only use attachments/accessories specied or provided by the manufacturer (such as the
exclusive supply adapter, battery etc.).
Please refer to the information on the product enclosure for electrical and safety information
before installing or operating the apparatus.
To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture.
The ventilation should not be impeded by covering the ventilation openings with items, such as
newspaper, table-cloths, curtains, etc.
The apparatus shall not be exposed to dripping or splashing and no objects lled with liquids,
such as vases, shall be placed on the apparatus.
This mark indicates a risk of electric shock.
To prevent injury, this apparatus must be securely attached to the oor/wall in accordance with
the installation instructions.
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent
types.
The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as
sunshine, re or the like.
Excessive sound pressure from earphones and headphones can cause hearing loss.
Listening to music at high volume levels and for extended durations can damage one's hearing.
In order to reduce the risk of damage to hearing, one should lower the volume to a safe,
comfortable level, and reduce the amount of time listening at high levels.
The mains plug or appliance coupler is used as disconnect device, it shall remain readily operable.
When not in use and during movement, please take care of the power cord set, e.g. tie up the
power cord set with cable tie or something like that. It shall be free from sharp edges or similar
which can cause abrasion of the power cord set. When put into use again, please make sure the
power cord is not damaged. The absence of a light indication on the apparatus does not mean
that it is fully disconnected from the mains. To disconnect the apparatus completely, the mains
plug must be pulled out.
Attention should be drawn to environmental aspects of battery disposal.
No naked ame sources, such as lighted candles, should be placed on the apparatus.
To prevent the spread of re, keep candles or other open ames away from this product at
all times.
Equipment with this symbol is a Class II or double insulated electrical appliance. It has been
designed in such a way that it does not require a safety connection to electrical earth.
Precautions
Never try to open the device. It is dangerous to touch the inside of the device due to high voltages
and possible electrical hazards. Opening the device will void the warranty of the product. Refer all
maintenance or servicing to suitably qualied personnel.
When you are connecting cables, be sure that the device is disconnected from the mains
supply voltage. Wait a few seconds after switching o the device before you move the device or
disconnect any equipment.
3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Strong SRT 8222 and is the answer not in the manual?

Strong SRT 8222 Specifications

General IconGeneral
Aspect ratio16:9
Signal sourceTerrestrial
Video resolutions704 x 576, 720 x 576, 848 x 720, 1080 x 720, 1280 x 720, 1440 x 1080, 1920 x 1080 pixels
Supported video modes576i, 576p, 720p, 1080i, 1080p
Digital signal format systemDVB-T2
Personal Video Recorder (PVR) included-
Audio formats supportedAC3, MP3, PCM
Image formats supportedBMP, JPG
Video formats supportedH.264, H.265, MPEG2, MPEG4
Wi-FiNo
Ethernet LANYes
USB 2.0 ports quantity1
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity0
Tuner typeDigital
Product colorBlack
Audio decodersDolby Digital, Dolby Digital Plus
Number of tuners1 tuner(s)
Channels quantity400 channels
Audio output channels- channels
Screen format adjustments4:3, 16:9
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)1 W
Power consumption (typical)10 W
Storage temperature (T-T)-25 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 85 %
Display typeLCD
Weight and Dimensions IconWeight and Dimensions
Depth105 mm
Width170 mm
Height40 mm
Weight270 g

Related product manuals