Strong SRT 8222 - 7.8 System

RAW HDMI O No audio will be forwarded to the outputs.
Audio Description AD. Useful for the visual impaired. If you like to have support of an audio track
that describes the content on screen, select the volume from the AD audio
track. Default is O.
NOTE: Audio Description depends on the broadcaster inserting such an
accompanying audio track.
7.8 System
Setup some system own features for maintenance, network and protection.
Parental Guidance Programmes with a Parental Guidance Rating can be blocked from viewing
and opened only with a Password. To setup this feature, enter your password
rst. Then select an age, above which the channel must be protected.
Options are: O, 1 to 18. Default is O.
Set password To set another password than the default one, enter the old 4-digit password
rst, then enter a new password and conrm it, by entering it again.
Restore Factory Default Reset your receiver to the default factory settings. Sometimes useful if the
unit suddenly behaves in an unexpected manner, e.g. after a power failure.
Select System then Restore Factory Default in the main menu and press OK to
select. Enter your password or the DEFAULT password: 1234 and press OK
to conrm. Note: This option will delete all your channels, Favourite lists and
settings. The receiver will reboot and start with the initial Installation menu.
Information This submenu shows receiver specic information such as hardware and
software version. Please have the Information screen on hand when you call
our hotline. The person who answers your call might ask for the information
given in this screen.
Software Update This feature allows you to update the receiver software via the USB port.
When a new software is available for your receiver, it can be downloaded
from our website. Place the software le (unzipped) in the root directory of
your USB storage device (HDD, memory stick etc.) and connect the device to
the USB port of the receiver. First a message box will appear that a USB device
is found. Then go to the System menu and select the Software Update option.
Select the correct le in the list. Press OK to start update. When ready, the unit
will reboot automatically.
Recall List If set to On, a list of last watched channels will be displayed in viewing mode,
when the RECALL button on the remote control is pressed. Choose the
channel to go back to and press OK. If set to O, the RECALL button will
instantly return to the previous watched channel.
Network Setting Setup your Network connection to use the Network Apps.
Link Type is LAN, for use with a wired network to a router/modem on the RJ45
Ethernet port.
IP Setting Press OK to open the submenu.
DHCP If DHCP is set to On, the unit will auto-negotiate with the router/
modem for the correct IP settings, assuming the router/modem also being
set to DHCP On. This is the common default. If you like to use dierent IP
16