Structural Concepts Oasis B32 - Front Grille Removal; Condenser Package; Overflow Pan; Main Power Switch; Removable Front Grille Procedures; Condensate Pan Connection Check; Turning On Power to the Case

10
FRONT GRILLE REMOVAL / CONDENSER PACKAGE / OVERFLOW PAN / MAIN POWER SWITCH
1. Removable Front Grille
• Front grille can be removed/replaced via thumbscrew
and magnet removal method (shown top-right) OR slot
and hook method (shown lower-right).
• Also, hook/magnet method (shown lower-left).
2. Check That Overflow Condensate Pan is
Properly Connected To Outlet
• Caution! Condensate pan can come unplugged
from its electrical outlet during shipment!
• If case runs without proper connection, water will
overflow pan and drain onto floor causing damage!
• Before turning case on, check that power cord from
condensate pan is properly plugged in.
• See TROUBLESHOOTING section in operating
manual for additional information.
3. Turning On Power To Case
• Plug in power cord.
• Main power switch may be turned on by reaching
through front grille; however, removal of front grille will
allow unhindered access.
• Main power switch is located on main ballast
box, below controller. See illustration at right.
Thumbscrew
Location
Thumbscrew
Location
Magnet
Magnet
Main Power
Switch
Carel®
Thermostat
Condenser
Coil
Thumbscrews
Front
Panel
Front
Panel
Slots (Typ.)
Hooks
Thumbscrew Controlled Front Panel
Shown In Above Illustration
Front Panel With Slots and Hooks
Shown In Above Illustration
Front Panel Style That Rests on Hooks And Attaches
To Magnets (Model B32.7413 Shown)
Hooks
Magnet
Magnet