31
ANNUAL PREVENTIVE MAINTENANCE INSTRUCTIONS
Optional Clean Sweep® Condensing Coil Cleaner:
Important! Disconnect power from case before cleaning the Clean Sweep® Condenser Coil Cleaner!
• Remove front grille (by removing 4 screws).
• Slide/roll out condensing unit assembly.
• Remove the four (4) screws holding Clean Sweep® rails intact.
• Remove the Clean Sweep® rail.
• Wash rail and brushes in hot water and mild soap solution.
• If brushes are worn, they must be replaced. Call Technical Service Department to replace.
Toll-Free number is listed at end of manual.
• Caution! Coil fins are sharp. Handle with care!
• Reattach Clean Sweep® rail to condensing unit (4 screws).
• Slide/roll condensing unit assembly back under case.
• Replace front grille to case in same manner it was removed.
• See photos below.
(4) Screws
--- Above photos are taken after front grille has been removed from case ---
Brushes Rail
PREVENTIVE MAINTENANCE - TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY - 5 of 5
To Next Page
Loading...
