To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...How to fix Stryker Medical Equipment jack that will not raise to full height?
To address a Stryker Medical Equipment jack that won't raise to its full height, begin by adding hydraulic fluid as indicated on page 12. Additionally, inspect the equipment for any leaks that may be preventing it from reaching its maximum extension.
What to do if Stryker 1000 Medical Equipment jack will not hold in raised position?
If your Stryker Medical Equipment jack fails to hold in the raised position, start by completely closing the needle valve. If the jack then holds, the solution is to replace valve #1, as detailed on page 14. However, if the jack still does not hold its position, proceed to replace valve #2, as instructed on page 15.
Why Stryker 1000 jack will not pump up and the jack actuator rod does not move?
If the Stryker Medical Equipment jack won't pump up and the actuator rod remains stationary, begin by closing the needle valve. If the jack then pumps up, the remedy is to replace valve #1. Should the jack still fail to pump up after closing the needle valve, replace valve #3, as described on page 15.
What to do if Stryker 1000 jack will not pump up but the jack actuator rod does move when the pump pedal is activated?
If the Stryker Medical Equipment jack does not pump up, but the actuator rod moves when you activate the pump pedal, you should replace valve #2, as instructed on page 15.
General| Manufacturer | Stryker |
|---|---|
| Model | 1000 |
| Application | Patient Transport |
| Technology | Hydraulic Lift |
| Compatibility | Standard hospital beds |
| Portability | Mobile with locking casters |
Explains the meaning of safety and operational terms used in the manual.
Step-by-step guide for adjusting the pneumatic fowler mechanism.
Adjusting the pedal linkage for dual side and end control bases.
Instructions for replacing caster assemblies on the stretcher.
Identifies common hydraulic system issues and their solutions.
Procedures for replacing hydraulic check valves #1, #2, and #3.
Outlines the terms and conditions of the product's limited warranty.
