Stryker FL28C - Page 17

Troubleshooting Chapter 3
17
Scale display (optional) does not turn on when
the scale is activated.
• Press ENTER key twice.
• Turn the main power switch off and turn it
on.
• Lift the foot board and gently replace it into
position taking care to completely push it
down so that the connectors match
correctly.
• Check points of the “No power to bed”
problem described above.
• Scale user interface cable not properly
connected or completely disconnected from
the scale control board (J6 connector, see
drawing L28-008 in the parts list manual).
Scale (optional) displays "No scale found".
• Press the ENTER key. If message
persists, contact our Technical Service
(see section 1.2).
If message disappears, data displayed is
correct and current procedure can be
resumed.
All lockout LEDs (padlock icons) flash or the
word Error appears at the bottom of the LCD
display.
• The scale is unable to measure the
weight due to an electrical problem.
Please contact our Technical Service
(see section 1.2).
Bed Exit system (optional) does not operate
properly.
• Verify that the load cell cables are properly
connected to the scale control board (see
figure 4.3E, page 38 for the illustration of
the load cell cable connecting positions).
Bed Exit system (optional) does not work at all
or alarm goes off when Bed Exit is activated.
• Check points of the “No power to bed”
problem described above.
• One or more load cell cable are not
properly connected or are completely
disconnected from the scale control board
(see figure 4.3E, page 38 for the load cell
cable connecting positions).
Nurse call (optional) or Bed Exit (optional)
signal does not reach the nurse desk.
• Check points of the “No power to bed”
problem described above.
• Check the connecting cable.
• Check the wall outlet.
• Contact the Technical Service (see 1.2)