Maintenance Procedures Chapter 4
49
4.4 BASE MAINTENANCE PROCEDURES
BRAKE/STEER PEDAL REPLACEMENT
Required Tools:
1/2" Socket Wrench Soft Hammer
Procedure:
1. Raise the bed fully up.
2. Unplug the bed power cord from the wall outlet.
3. Remove the optional steer wheel hood.
N
N
O
O
T
T
E
E
When reinstalling the steer wheel hood, make sure the colors (green and red) of the stickers
affixed on the hood and the brake/steer pedal match.
4. Position the brake/steer pedal to neutral.
5. Using a 1/2" socket wrench, remove the two bolts (A) holding the steer wheel support on the
side of the defective pedal and lay the support down. Keep the molded spacer (B).
6. Using a soft hammer, remove the pedal from the activation lever shaft.
7. Reverse the above steps to install the new pedal.
B
E
D
D
F
G
F
Figure 4.4A
To Next Page
Loading...
