Pr eventative Maintenance Chapter 2
9
2. PREVENTATIVE MAINTENANCE
2.1 BED CLEANING AND MATTRESS CARE
When large fluid spills occur in the area of the circuit boards, cables and motors, immediately
unplug the bed power cord from the wall outlet, remove the patient from the bed and clean up
the fluid. Have maintenance completely check the bed. Fluids can have an adverse effect on
operational capabilities of any electrical product. DO NOT put the bed back into service until it is
completely dried and has been thoroughly tested for safe operation. Ensure, among other
things, that the plastic components being used as covers for the siderail mechanism arms and
the foot end casing are removed and that the parts they cover are thoroughly dried.
Do not use harsh cleaners, solvents or detergents. Equipment damage could occur. Do not
steam clean, hose off or ultrasonically clean the bed. Do not immerse any part of the bed. The
bed electrical parts may be damaged by exposure to water.
Germicidal disinfectant, used as directed, and/or Chlorine Bleach products are not considered
mild detergents. These products are corrosive in nature and may cause damage to your bed if
used improperly. If these types of products are used, ensure the beds are wiped with clean
water and thoroughly dried following cleaning. Failure to properly rinse and dry the beds will
leave a corrosive residue on the surface of the bed, possibly causing premature corrosion of
critical components. Failure to follow the above directions when using these types of cleaners
may void this product warranty.
CLEANING BEDS
Hand wash all surfaces of the bed with a soft cloth moistened with a solution of lukewarm water
and a mild detergent.
Wipe the bed clean and dry thoroughly to avoid build up of cleaning solution.
MATTRESS CARE
Inspect the mattress after each use. Discontinue use if any cracks or rips, which may allow fluid
to enter the mattress, are found in the mattress cover. Failure to properly clean the mattress, or
dispose of it if defective, may increase the risk of exposure to pathogenic substances and
may
bring about diseases to the
patient and user.
• Inspection
Implement local policies to address regular care, maintenance, and cleaning of mattresses and
covers. The cover cleaning procedure can be found below and on the bed label.
Inspect the mattress cover inner and outer surfaces and the zip fasteners regularly for signs of
damage. If the mattress cover is heavily stained or soiled, or is torn, remove the mattress from
service.
• Cleaning
Stains: Wash with lukewarm water using a mild detergent. Rinse with water and let dry. For
tough stains, use bleach diluted with ten parts of water.
C
C
U
U
T
T
I
I
O
O
N
N
W
W
A
A
R
R
N
N
I
I
N
N
G
G
W
W
A
A
R
R
N
N
I
I
N
N
G
G
To Next Page
Loading...
