Mai ntenance Procedures Chapter 4
21
SIDERAIL OUTER PANEL MEMBRANE REPLACEMENT
Required Tools:
Small Slotted Head Screwdriver No. 2 Phillips Screwdriver
Procedure:
1. Run the bed fully up and apply the brakes. Raise the siderail needing repair.
2. Unplug the bed power cord from the wall outlet.
3. Using a small slotted head screwdriver, lift and remove the following self-sticking parts: the
outer membrane (A), the two screws covers (B) and the "Lift to release siderail" sticker (C)
to expose the screws holding the siderail cover. Proceed gently when inserting the
screwdriver under the stickers to avoid damaging the cover.
N
N
O
O
T
T
E
E
Do not reuse the self-sticking parts removed since their self-adhesive coating considerably
looses its efficiency once they are removed. Replace them with new parts.
4. Using a Phillips screwdriver, remove the eight screws (D) holding the cover to the siderail
and remove the cover.
The eight screws (D) must be replaced with new identical screws because their Scotch-Grip
coating is less efficient once they have been tightened and removed thereafter.
5. Disconnect the defective membrane and remove it.
6. Reverse the above steps to install the new membrane.
7. Test all controls of the control panel for proper operation before reassembling the siderail
and returning the bed to service.
W
W
A
R
R
N
N
I
I
N
N
G
G
Figure 4.1C
C
B
C
E
D
D
F
G
H
H
I
To Next Page
Loading...
