Maintenance Manual
18
4. MAINTENANCE PROCEDURES
Only field technicians from Stryker or service personnel trained by Stryker should perform the
procedures detailed in this maintenance manual, especially those related to the Scale (option)
and Bed Exit (option) systems. Failure to observe this restriction can result in serious damage to
material and/or severe injury to people.
To prevent injury when working under the bed with the bed in the high position, always place
blocks under the mattress support frame and apply the brakes.
Always unplug the bed power cord from the wall outlet when servicing or cleaning the bed.
NOTE
Throughout this maintenance manual, the words “right” and “left” refer to the right and left sides
of a patient lying face up on the bed.
4.1 SIDERAIL MAINTENANCE PROCEDURES
HEAD SIDERAIL ASSEMBLY REPLACEMENT
Required Tools:
1/2" Wrench 3/16" Allen Key Cutting Pliers
Procedure:
1. Run the bed fully up and apply the brakes.
2. Remove the head section plastic cover (optional). Fully raise the head section and raise the
siderail needing repair.
3. Unplug the power cord from the wall receptacle.
4. Loosen the lock ring (A) and unplug the siderail cable.
5. Using cutting pliers, remove the Ty-raps holding the siderail cable to the frame.
6. Using a 3/16" Allen key and a 1/2" wrench, remove the four locknuts/bolts (B) holding the
siderail assembly to the head section and remove the assembly. Support the assembly
when removing the last bolts.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
Figure 4.1
B
B
To Next Page
Loading...
