Stryker FL28C - Maintenance Procedures: Mattress Support and Actuators; Mattress Support Section Replacements

Maintenance Manual
26
4.3 MATTRESS SUPPORT MAINTENANCE PROCEDURES
FOOT SECTION REPLACEMENT
Required Tools:
1/2" Wrench No. 2 Phillips Screwdriver Bungee Cord
Procedure:
1. Run the bed fully up and apply the brakes. Flatten all sections of the mattress support.
2. Unplug the bed power cord from the wall outlet.
3. Lower the siderails.
4. Remove if applicable the foot section plastic cover (optional). Lift and fold back the foot
section toward the head end of the bed and secure it to the bed using a bungee cord.
5. Remove the foot end mattress retainer (A) and install it on the new foot section. Replace the
foot section to horizontal position,
6. Using a 1/2" wrench, remove the two locknuts/washers/shoulder spacers/bolts (B) linking
the foot section to the thigh section and remove the defective section.
7. Reverse the above steps to install the new foot section.
Figure 4.3A
A
B
C
D
E
E
F
G
H