5. Select “Set” by operating the “ ” or
“
” switch and confirm the setting by
pulling the “
/SET” switch toward you.
6. The system will notify you that the
setting is complete.
NOTE
. The notification will be displayed
with information of both date and
distance or either date or distance in
accordance with the setting
. When “__” is selected for either the
“Month”, “Day”, “Year” or “Distance”
item instead of numbers, the set noti-
fication will be deactivated.
. If the notification continues for 15
days or more, the system will display
“__” on the screen.
. When the distance announcement
reaches 0 mile (0 km), the display will
show “0000” for the next 311 miles (500
km). After exceeding 311 miles (500
km), “____” will be displayed.
! Oil filter setting
The setting procedure is the same as
“Engine oil setting” F3-58, but select the
“Oil Filter” item in step 2.
! Tires setting
The setting procedure is the same as
“Engine oil setting” F3-58, but select the
“Tires” item in step 2.
! Maintenance schedule setting
The setting procedure is the same as
“Engine oil setting” F3-58, but select the
“Maintenance Schedule” item in step 2.
! On/Off setting
1. Perform the preparation steps accord-
ing to “Preparation for maintenance set-
tings” F3-57.
2. Operate the “ ” or “ ” switch to
select the “On/Off” item. Then pull the “
/
SET” switch toward you.
3. The current setting will be displayed.
Pull the “
/SET” switch toward you to
enter the selection mode.
Instruments and controls/Multi function display
3-59
– CONTINUED –
To Next Page