97
1.) Switch on WIRELESS (MASTER) on the left edge. The switch on 3 more units has to be set on
“0”.
2.) Red and white LED lights start to flash alternately. This shows that the device is waiting for
the 8-digit code to identify the system of devices. Please write down the key sequence,
written down in the chart on the next page, as it has to be used for all devices´ configuration.
3.) Enter 8-digit code using the following buttons:
In this phase all other buttons will be deactivated. If pressed, they won´t give an acoustic signal.
Example: General code for units master, slave1 and slave 2
UNIT
BUTTO
N 1
BUTTO
N 2
BUTTO
N 3
BUTTO
N 4
BUTTO
N 5
BUTTO
N 6
BUTTO
N 7
BUTTO
N 8
R
(living
room)
(single
room
(double
room)
If the code has been entered correctly, only the red LED light will be illuminated, the white light will
stay turned off.
ATTENTION: It is not permitted to press the same button 8 times, at least 1 button has to be
different. If an invalid code has been entered, the red LED light will be illuminated for 2 seconds.
Then the red and the white light will start to flash alternately, until a valid code is entered.
To Next Page
Loading...
Need help?
General
