107
7.0 SOLO
Speed selection (1/2)
Switching On / Off (0/1)
1) Start up
Once the product is installed by qualified personnel, proceed with the first start of the product, by
turning the switch "0/1", placed on the side of the main unit, on.
Make sure that the luminous indicator is on.
Once the shutter is open, the product starts its normal operation with the exchange cycle of 70
seconds of air inlet - 70 seconds of air extraction.
2) Speed selection
It is possible to increase or decrease the air exchange flow by means of the "1/2" switch, placed on
the product side.
Select speed 1 for more silent air exchange.
Select speed 2 for faster air exchange.
3) Wall controls
In the event that, during installation carried out by qualified personnel, the "On/Off" and "speed
selection" commands have been controlled from the wall, make sure that the controls on the
product are both turned on "1".
The instructions for remote control on the wall are identical to those of the product, mentioned
above.
4) Turning the product off
Set the switch "0/1", placed on the product side, on "0".
If the commands have been carried out on the wall, set the wall switch on "0". Keep the "On/Off"
switch, placed on the product side, in the "1" position.
7.1 ADVANCED AND WIRELESS VERSIONS
To Next Page
Loading...
Need help?
General
